Here is the shift summary:

On shift : Peter Maas, Stefano Bagnasco

Program  : Take data with neutral trigger (PBG 1 and PBG 3) and write
            tapes.

Notes    : At the beginning of the shift, problems with the DYC attached
           to the STRAWS and DYC 13 (SCIFI ADCs) cause runs to end.  Also,
           I/O errors on drives 7 and 8 halt several runs.  After
           removing the two DYCs, smooth running.

           Calorimeter and Neutral Trigger TDCs now read both leading and
           trailing edges.  Pedestal subtraction has been enabled in the
           Feras.

           After copying data file to disk, it was impossible to check the
           data as the offline crashed immediately.

Run     # of events     tapes     disk file                 comments

256      ~900,000     256A,256B   /calib2r/dump/run256a.dat STRAW DYC
                                  /calib2r/dump/run256b.dat

257       ??????      257A,257B                             STRAW DYC

259        42,000     --------                              I/O Error

260       830,000     260A,260B                             DYC 13

261                                                         NO LOG, TEST

262       100.000     --------                              I/O Error

263       836,572     263A,263B                             DYC 13

264                                                         NO LOG, TEST

265                                                         I/O Error

266    12,173,992     266A,266B                             END OF TAPE


          BEAM CURRENT       JET DENSITY

initial     13.5 mAmps         5.06 E 13
final       12.5 mAmps         5.08 E 13

loss rate fluctuates between 0.03 and 0.15 mAmps/hour

                                         Peter Maas